You can check the About page for the firmware version after the upgrade.
This firmware update is only compatible with the Snapmaker 2.0 devices.
Fixed a bug where the Save button isn’t greyed out during Manual Calibration.Added Enclosure APIs for remote control(Snapmaker Luban).We recommend that you should re-do bed leveling after changing the calibration settings.You can find the option in 3D printing advance settings.Adjusted the initial Z height in Manual Calibration.Fixed a bug where the controller doesn’t save current coordinates when there is a power outage.Here comes the latest version of the Snapmaker 2.0 firmware.
Thank you for your suggestions on how to make the Snapmaker 2.0 better.
As a result of the change, we recommend that you can:
Slow down Z bump speed when homing (G28) to get better consistency.įixed a bug that nozzle tip may hit the bed when moving to the next point in auto-leveling if probe sensor is assembled too high.įixed a bug that positions in manual leveling are not saved correctly.įixed a bug that controller may halt down when finishing print.įixed a bug that FANs are not recovered when recovered from Power-Loss.įixed a bug that machine may restart job when recovered from Power-Loss and immidiately trigger Filament runout.įixed a bug that home offset is cleared when resetting settings.Īdded an option for turning on/off anonymous data sharing (which is on by default).Īdded management pages for enclosure add-on.Įnhanced the stability of print data transmission.